Surface Coating of Plastic Parts and Products: National Emission Standards for Hazardous Air Pollutants (NESHAP)
On this page:
Rule Summary
The final rule implements section 112(d) of the Clean Air Act (CAA) by requiring these operations to meet HAP emission standards reflecting the application of the maximum achievable control technology (MACT). The final rule will protect air quality and promote the public health by reducing emissions of HAP from facilities in the plastic parts and products surface coating source category. The organic HAP emitted by these operations include methyl isobutyl ketone, toluene, glycol ethers, and xylenes.
The final standards are expected to reduce nationwide organic HAP emissions from major sources in this source category by approximately 80 percent. Emissions of methyl ethyl ketone, and ethylene glycol monobutyl ether included in emission reduction estimates; however, both HAP have been delisted since promulgation of the final rule.
Rule History
07/8/2020 - Final Rule
11/01/2019 - Proposed Rule
04/24/2007 – Proposed Rule & Direct Final Rule
12/22/2006 – Proposed Rule & Direct Final Rule
04/20/2006 – National Emission Standards for Hazardous Air Pollutants (NESHAP) General Provisions Final Rule
04/26/2004 – Surface Coating of Automobiles and Light-Duty Trucks Final Rule
04/19/2004 – Final Rule
12/19/2002 – Federal Register Correction
12/04/2002 – Proposed Rule
Additional Resources
Fact Sheet: Final Amendments (03/11/2020)
Related Rules
Control Techniques Guidelines for Miscellaneous Plastic Parts Coatings
Polymeric Coating of Supporting Substrates Facilities: New Source Performance Standards (NSPS)
Compliance
Compliance Timeline for Surface Coating of Plastic Parts and Products